singaporemili.blogg.se - Audio companion for leapfrog

#Audio companion for leapfrog install#
#Audio companion for leapfrog update#
#Audio companion for leapfrog download#

Routinely check this toy for proper and safe condition.This toy is only to be connected to equipment bearing either of the following symbols:.The USB cable should be used only by an adult when connecting to a computer and is to be removed by the adult prior to the use of the product by the child. Keep out of reach of children under 3 years of age. The USB cable could be a strangulation hazard.The unit can be turned on again by pressing the On/Off Button. Automatic Shut-Off To preserve battery life, the LeapStart® will automatically power down after approximately five minutes without input.Volume Control Press the and + Volume Control buttons to adjust the volume.Stylus Touch the tip of the Stylus to the book to interact with the pages.The LeapStart® learning system will start up and you will hear a welcome message. On/Off Button Press the On/Off Button.WARNING:Īdult assembly required for battery installation. Do not charge non-rechargeable batteries.Rechargeable batteries are only to be charged under adult supervision.Remove rechargeable batteries from the toy before charging.Remove exhausted batteries from the toy.Remove batteries during long periods of non-use.Do not short-circuit the supply terminals.Only batteries of the same or equivalent type as recommended are to be used.Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.Insert batteries with the correct polarity (+ and -).Replace the battery cover and tighten the screw to secure.(For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)

#Audio companion for leapfrog install#

Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box.Remove old batteries by pulling up on one end of each battery.Locate the battery cover on the bottom of the unit, use a coin or screwdriver to loosen the screw and open the battery cover.BATTERY INFORMATION Battery Removal and Installation Please visit /system-requirements for LeapFrog® Connect minimum system requirements. Your child is now ready to play, learn and explore with the LeapStart® system! PLAY & LEARN: Eject and disconnect the LeapStart® system from your computer.

#Audio companion for leapfrog download#

DOWNLOAD: Download companion audio for each of your books.

#Audio companion for leapfrog update#

REGISTER: Follow the instructions in the LeapFrog® Connect application to create a parent account and update your LeapStart® system.If instructed to download the companion audio, download the LeapFrog® Connect application at /connect and install it on your computer. SET UP: Snap a LeapStart® book into the Book Holders in your LeapStart® learning system and touch the tip of the Stylus to any image or word.POWER UP: Turn on the LeapStart® learning system.Your LeapStart® system is now ready to be used! Using LeapStart® Books The green Power Light will shine when the LeapStart® system is on. Install 2 AA batteries in your LeapStart® learning system.